Installation manual

Ý
Notice :
=
Either one of the above methods must be used or the
dishwasher will not operate properly.
= A hose that attaches to a sink spray can burst if it is
installed on the same water line as the dishwasher. If
your sink has one, it is recommended that the hose be
disconnected and the hole plugged.
= The total length of the drain hose is 76
3
/
4
 (1950mm.)
If a hose extension is required, a drainage hose of equal
quality must be used.
The maximum length must not exceed 157
1
/
2
 (4000mm)
Otherwise, the cleaning process is negatively influenced.
Ý
Notice :
=
You must add a loop at least 28" (710 mm) above the
floor of the cabinet and above the drain connection in
the drain hose to prevent waste water from not draining
properly, and causing either poor washing results or a
bad odor.
Ý
Notice :
=
Check with local ordinance for type of air gap required.
6.6 DRAIN PREPARATION
6.6.1 UNDER THE SINK DRAIN
6.6.2 INSTALLING AN AIR GAP
6.6.3 DISPOSAL
The dishwasher drain hose may be connected to the drain
plumbing in one of three ways (Figure A, B, C).
Install a Y-branch tail pipe. (Figure A)
If the local ordinance requires an air gap (Figure B).
Remove the drain connection plug before attaching the
drain hose from the dishwasher.
Every disposal has a hook up for a dishwasher; consult
your disposer manual for correct connection. (Figure C)
Figure A
Figure C
Figure B
9