Installation manual
CAUTION
= Hot water supply line: Use minimum 3/8 O.D. copper
tubing or metal braided dishwasher supply line.
= Temperatures required for soldering and sweating
will damage the dishwashers water inlet valve so
if any such operation is needed, keep the heat
source min. 7
7
/
8
(200 mm) away from the
dishwashers water inlet valve.
= There should not be any sharp bends in the water
line that may restrict the water flow.
= Teflon tape or pipe tread compound must be used
for sealing the connection. Before connecting the
copper water supply line to the dishwasher, flush
it with hot water to clear any foreign material.
Ý
Notice :
WARNING
= Make sure the voltage and frequency listed on the
data plate correspond with the household electrical
supply. This data must correspond to prevent injury
and machine damage. Consult a qualified electrician
if in doubt.
= Only connect the dishwasher to the mains when
all installation and plumbing work is complete.
= Do not use any extension cord or portable outlet
device to connect the dishwasher to a power supply.
7.1.3 WATER SUPPLY CONNECTION
After connections are made turn on the water supply to
check for leaks.
After connections are made turn on the water supply to
check for leaks.
7.1.4. ELECTRICAL CONNECTION
7.1.5. Grounding Instructions
This appliance must be grounded. In the event of a
malfunction or breakdown, grounding will reduce the risk of
electric shock by providing a path of least resistance for
electric current. This appliance must be installed and
grounded in accordance with all local codes and ordinances.
Water supply may be connected to the dishwasher in one
of two ways:
= With metal braided hose.
= With copper tubing.
13