Installation manual
WARNING
= Improper connection of the equipment-grounding
conductor can result in a risk of electric shock.
Check with a qualified electrician or service
representative if you are in doubt whether the
appliance is properly grounded.
Install a strain relief (not supplied) into the opening on
the kick plate. (Figure A)
Pass the electrical supply cable through the strain relief;
make sure the strain relief clamps the insulated outer
casing of your electrical supply cord and not the wires
themselves. Leave 2
15
/
16
" " to 3
15
/
16
" " (75 mm / 100 mm)
of insulated wire extending through the strain relief
(Figure B). Tighten the strain relief screws. (Make sure
you can not pull the electrical
cord out) of the strain relief.
Do not pre-twist the wires before connecting them with
wire nuts.
Using the supplied wire nuts, connect the electrical supply
wires to the dishwashers wires, black to black, white to
white, and green or bare to green or bare. Make certain
that the insulated wires show no bare wire from the
bottoms of the wire nuts. Gently tug the wires to make
certain they are securely connected.
(Figure C)
14
Figure B
Figure A
Figure C