Installation manual

A
s
t
C
B
o
p
?
?
Figure A
7.4
INSTALLING THE OUTER DOOR
(DWT 34200, DWT 35200, DWT 36200, DWT 37200)
Measure the height and width of the enclosure (Figure A)
and the toe kick. Determine how big the wooden door can
be. For example if the height is 34 (864 mm) and if the toe
kick is
3
15
/
16
 (100 mm) the door can not be taller than
30 (762 mm).
1. Prepare the wooden door with the mounting brackets.
Height : Height of the wooden door 30 (762 mm)
Width : 23 ¼
to 23 ½ (592 mm - 595 mm)
Thickness : ¾  (19 mm)
2. Remove the plastic mounting brackets from the
dishwasher (Figure B).
17
Figure B
If the enclosure height is above 34
1
/
14
 (870 mm) use o
and p labelled toe kicks together. Make sure the slotted
toe kick
p is on the outside so you can adjust height of the
toe kick. Installation should be done following the steps
illustrated in the figures A, B and C respectively.
1. Align the toe kick (o) and (p) (A).
2.
Secure toe kicks to brackets with screws (t) after adjusting
the height of the slotted toe kick (
p) (B).
3.
Attach caps (s) as shown in the supply bags (C).