Installation manual
Ý
Notice :
Ý
Notice :
Ý
Notice :
Ý
Notice :
Your installer must have completed and checked
the following:
= The dishwasher is square and level.
= The dishwasher is fastened securely to the
cabinetry.
= The dishwasher door opens and closes freely.
The dishwasher door must close without hitting
any cabinetry or counter top.
= The inlet water supply is turned on and checked
for leaks.
= The drain hose has been connected and checked
for leaks. There must be no kinks or obstructions
in the drain hose.
= The drain hose must be installed with a 28" (710
mm) high drain loop for drain hook-ups without
any air removed.
= If the dishwasher drain is hooked up to a garbage
disposal, the drain hopper plug must be removed.
= The spray arms are free and rotate freely.
= The rinse cycle has been run.
= The water level will be below the filter screen
after the end of the wash program. It is normal
to find some water in the drain filter area.
= Set the water softener to the correct water
hardness for your area. If the dishwasher drain
is connected to a garbage disposal, make sure
that the drain/hopper plug has been removed.
8. INSTALLER CHECKLIST
9. FINAL INSTRUCTIONS
10. SELF HELP HINTS:
The installer is responsible for the dishwasher
installation. Incorrect installation is not covered by
the warranty.
Please make a copy of your invoice and keep it with this
manual and register your dishwasher on-line.
If the dishwasher does not operate properly, refer to the
self help hints.
1. Press the On/Off button to turn the dishwasher
on.
2. Power indicator light comes on.
3. Use the Cycle Select button to choose a washing
program.
4. Start the program with the Start/Pause button.
5. Run the dishwasher through one complete cycle.
When the progress indicator light End lights
up, the wash cycle is completed. Use the On/Off
button to turn the dishwasher off.
The power indicator light doesnt come on:
= Check to make sure the breaker to the dishwasher
is in the on position
.
= Check all the wire connections in the junction box
are tight and not loose.
= If your dishwasher is not operating properly after
following these steps: Contact your dealer to
schedule an authorized service agent to inspect
your new dishwasher for any function related failure.
= The manufacturer warranty does not cover
installation or customer education service visits.
You will find the model and serial number information
on the label located on the right-hand side of the inner
door of your dishwasher, as shown above.
No Water is coming into the dishwasher
:
= Check to make sure the hot water shut-off is in the
ON position.
Water does not drain
:
= Make sure drain hose is not kinked or comes out of
air gap next to the sink.
= Remove drain hose from disposal making sure plug
is removed.
23
Installation Manual-USA
DWT xxxxx xxxxx