Owner's Manual

8 - EN
A WARNING - Risk of fire
• Theclothesdryer(“appliance‘)installation
must be performed by a qualified installer.
• Installtheapplianceaccordingtothe
manufacturer’s instructions and local codes.
• Donotinstallaclothesdryerwithflexible
plastic venting materials. If flexible metal
(foiltype)ductisinstalled,itmustbeofa
specific type identified by the appliance
manufacturer as suitable for use with
clothes dryers. Flexible venting materials are
known to collapse, be easily crushed, and
trap lint. These conditions will obstruct the
clothes dryer’s airflow and increase the risk
of fire.
A To reduce the risk of severe injury or
death, follow all installation instructions.
SAVE THESE INSTRUCTIONS
Electrical connection
Connect the appliance to a grounded outlet
protected by a fuse or circuit breaker of
suitable capacity.
3-Wire Electrical Connection
If your receptacle is a 3-wire receptacle as
shown below, you must obtain a 3-wire dryer
cord. A dryer cord can usually be found at
your local hardware supply, electrical supply or
home center. Cord should have closed loop or
upturned end wire terminating connectors.
A If the dryer is installed in a mobile home,
recreational vehicles, new branch-circuit
installations or in areas where local codes do
not permit grounding, only a 4-wire power
supply cord shall be used.
To change the cord:
1. Make sure that the dryer is not plugged into
any power outlet.
B DO NOT plug end of dryer power cord
into a live receptacle before connecting dryer
power cord to dryer terminals and closing
junction/splitter box as described below.
B DO NOT repair old power supply cords.
Powercordmustbechangedonlybya
qualified person. There is a risk of electric
shock!
2.Removethescrewfromthecoverofthe
junction box located at the top rear of the
dryer.
3.Removethered,whiteandblackwirefrom
the terminal block.
4.Removethegreengroundwirefromthe
ground terminal.
5. Loosen the strain relief clamp holding the
4-wire cable.
6. Thread the 4-wire cable out through the
strain relief clamp.
7. Thread the new 3-wire dryer cord through
the strain relief clamp.
3- wire receptacle
( 10-30R)
Typical 3- Wire Dryer Cord 240V/30 amp
NEMA 10-30 Type SRDT
3 Installation Instructions
4-wi re r ecep tacle
(14 -30R)
3-wi re r ecep tacle
(10 -30R)
If yo u have 3-wir e receptacle, like
this , a 3-wire dryer cord mus t be
purc hased locall y.
Dryer shipped with cord to fit this
type 4 -wire receptacle