User manual
13 / EN
Dryer / User Manual
•Place the appliance on a solid floor. If
it is to be placed on top of a washer, the
approximate weight together may reach 397
lbs (180 kg) when they are full. Therefore,
the floor must be capable of carrying the load
placed on it!
3.6 Adjusting the feet
In order to ensure that your appliance
operates almost silently and vibration-free,
it must stand level and balanced on its
feet. The front feet of the appliance can be
adjusted. Balance the appliance by adjusting
the feet.
C
Do not use any tools to loosen the
adjustable feet. Otherwise, they
may be damaged.
C
Never unscrew the adjustable feet
from their housings.
2 plastic pieces supplied together with
the Operating Instructions prevent your
appliance from slipping on wet and slippery
surfaces. To install these plastic parts:
1. Tilt the appliance backwards.
2. Fit the plastic parts to the front adjustable
feet. Press on the plastic parts to fix them in
their places.
3. Check the balance of the appliance again
and readjust the adjustable feet if necessary.
1. Loosen the feet by hand.
2. Adjust them until the
appliance stands level and
firmly.
3.7 Ventilation duct and
connection
Ventilation duct ensures exhaust of air from
inside the appliance.
The vented dryer has 1 air outlet.
A
Only rigid or flexible metal duct
should be used for exhausting.
• In Canada, the diameter of the duct to
be used should be 4” (102 mm). In United
States, the regulation for the required
exhaust duct diameter must be followed.
Maximum duct length is given in the table
below:
Metal rigid duct
Maximum
length
72 ft (21.9 m) + 2 elbows
To connect a ventilation duct;
1.Connect the air outlet metal duct to the
spacer by turning it counter-clockwise.
2.Make the duct passages as shown in the
illustration below.