Dishwasher Instruction Manual
Dear customer, Please read carefully right through this instruction booklet before installing or operating your dishwasher. The following instructions should prevent the risk of personal injury and/or damage to the appliance. Please keep these documents in a safe place for later reference. This operating manual has been written for several different machines, and some of the features mentioned here may not apply to your particular model.
TABLE OF CONTENTS 1 Getting To Know Your Machine 3 View of the Machine 3 2 Safety Instructions 4 3 Directions for Assembly 6 4 Using Your Dishwasher 9 Before Installation 4 Before First Use 4 Child Safety 4 Technical Specifications 4 For daily operation 5 Problems 5 What should not be washed in your dishwasher 5 Safety notes for installation Installing Your Dishwasher Water connection Connect water inlet hose Water drainage Electrical connection Disposal Filling the dishwasher salt When ope
1 Getting To Know Your Machine View of the Machine �� � � � �� � �� � � � � � �� 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13.
Technical Specifications our specifications and designs without prior notice. Permitted water pressure: 0,3 –10 bar (= 3 – 100 N/cm² = 0,01-1,0Mpa) Electrical connection: 220-240 Volts, 10 Amps (see type plate) Output: 1900-2200 W Heat output: 1800 W Note for Testing Institutes The necessary information for performance testing will be provided upon request.
• • • • • • • • • while the appliance is open, as the appliance may still contain detergent leftovers. The water in the dishwasher is not drinking water. Danger of caustic injuries. Always place long and sharp/ pointed objects (e.g. serving forks, bread knives) into the cutlery basket with the pointed end down or flat on the upper basket to avoid possible injuries. • • • For daily operation Use your appliance only for the following domestic uses: Washing household dishes.
3 Directions for Assembly Safety notes for installation Installing Your Dishwasher • Choose a suitable location for your Prior to installing and using your appliance, please check it for possible transit damage. If the appliance is damaged, please contact your supplier. • Never install or use a damaged appliance. The following directions must be followed to connect the dishwasher properly.
Water connection Permitted water temperature: up to 25°C • The dishwasher may not be connected to open warm water devices or flow-through water heaters. Permitted water pressure: Lowest permitted water pressure: 0.3 bars = 3 N/cm² = 30 kPa When the water pressure is below 1 bar, please contact your technician. Highest permitted water pressure: 10 bar = 100N/cm² = 1Mpa When the water pressure is above 10 bars, a pressure reduction valve must be installed (available in trade supply stores).
Water drainage Connecting the drainage hose. Take care to ensure that the drainage hose is not bent or squeezed. 1011 ��� �� �� The maximum length must not exceed 4m. Using a longer hose will produce poorer cleaning results. Siphon connection The drainage height must be between 50 and 100cm above the floor. �� � �� �� �� �� ������� �� ��������� �� ���� ���������� ��� Check that the drainage hose is firmly seated.
Packaging materials may be dangerous to children. Reusable substances may be dropped off at your local disposal facilities. You may obtain further information from your local authorities and disposal facilities. Materials used are recyclable according to their labelling. Reuse, recycling of materials and further reutilization of used products are important contributions to protect our environment.
When operating for the first time: • Pour 1 litre of water into the salt � container (Fig. C). • Pour the salt into the container with the aid of the salt funnel provided (Fig. D). • Pour in enough salt to fill the container. The container holds approx. 2 kg. � • To speed up the rate of dissolution of salt in water, stir it with a spoon. • Close the cap tightly. • Begin a washing program immediately after filling the salt container.
Filling the Rinse Aid Dispenser Rinse aids allow washing water to rinse off more cleanly and prevent watermarks or streaks on the dishes. Only use rinse aid designed for use in dishwashers. If you use “2 in 1” or “3 in 1“ detergents / tablets, you do not need an additional rinse aid. 1013 � Open the rinse aid dispenser by pressing the locking lever (B) Carefully pour in rinse aid to the MAX mark. Close the lid until it clicks (3). � Carefully wipe off spilled rinse aid.
The detergent container holds a total of 40 cm³ of detergent (1). Detergent When the dishwasher is fully loaded and the dishes are very dirty, we recommend filling the detergent container up to the 25 cm³ mark. When the dishes are less dirty, it is generally sufficient to fill the detergent up to the 15 cm³ mark. Keep the opened detergent packages in a cool and dry place where children can not reach.
Excessive usage of powder detergents can cause the detergent not dissolve completely and can also cause scratches on the glassware. Contact the detergent producer if your dishes are wet and/or if you notice lime spots particularly on your glasses after the washing program is over. Multipurpose Detergents When you give up using such detergents: The best washing results in dishwashers is obtained by using detergent, rinse aid and water softening salt individually.
• • • • The movement of the spray arms must not be hindered Place all large and very dirty items in the lower basket. Small and light items can go into the upper basket. Long and narrow items are placed in the middle of the baskets. Knives and other utensils with sharp tips and edges must be placed horizontally into the upper basket due to risk of injury.
2 folding plate support rods (depends on the model) There are two separate “folding plate support rods” in the lower basket of your dishwasher designed to allow you more space to accommodate saucepans and large bowls in the lower basket. You can either fold each section (1, 2) individually or, all at once, to create a large empty space. Simply press the handgrips (A) and fold them down” � � 1054 � Bottle holder (depends on the model) For cleaning your bottles.
Variable cutlery basket (depends on the model) The variable cutlery basket can be separated into 3 parts depending on the amount of cutlery and the degree of dirtiness. Small cutlery basket sections also fit into the upper basket. � To do this, turn the lock on the handle to the right (A). Pull the smaller cutlery basket upwards and out of its holders (B). To put the parts together again, proceed in the opposite direction.
Cutlery Basket (depends on the model) Movable Cutlery Basket (depends on the model) Designed to allow free placement of the dishes according to their size, the movable cutlery basket can slide over the tines to the left (A) and right (B) side.
Basket insert with variable height settings (depends on the model) You can also use this insert in the lower basket for glasses and longhandled cutlery / utensils. If you do not need the insert, fold the rack upwards at the angle shown (A). Push the entire insert upwards (B). Place the insert in the upright position (C). Push the insert downwards and lock it into place with the holder (D). 1019 When you want to use the basket again, reverse the procedure.
Loading suggestions Load the upper basket with dessert plates, cups, glasses etc. 1027 Upper basket with variable height setting (depends on the model) The upper basket is equipped with a lifting mechanism which enables you to change the height of the basket without having to remove it from the dishwasher, even if it is fully loaded. The height of the upper basket was set to its lowest position at the factory.
Upper basket with variable height setting (depends on the model) The upper basket is equipped with a lifting mechanism which enables you to change the height of the basket without having to remove it from the dishwasher, even if it is fully loaded. The height of the upper basket was set to its lowest position at the factory. To lift the upper basket to the “high” (A) position, hold it on one side and carefully pull it upwards.
Height setting with empty basket (depends on the model) In this model, the height setting of the upper basket may be changed using the wheels which are mounted at two different heights. Release the latches on both the right and left tracks of the upper basket by pushing them outwards (C). � Pull out the basket out completely (D). Place the basket back into the tracks at the desired height (E). Push the latches back into the correct position.
Glass Support (depends on the model) When placing the glasses or goblets with a long grip, lean them against the glass support, the edge of the basket or the shelf but not against the other pieces. Do not lean the long glasses against each other, otherwise they do not remain stable during washing cycle and may get damaged. When you need to place the bulky pieces into the upper basket, disconnect the lug of the glass support from the bar of the basket where it is attached to.
5 How to clean your dishwasher Cleaning your machine at regular intervals ensures longer product life and reduces the risk of reccurring problems. Always unplug the machine and turn off the water supply before cleaning. Use a gentle household cleaner for the outside and the door seals. Clean the control panel only with a moist cloth and clear water. � � Cleaning the filters � Clean the filters and the spray arms regularly. A dirty machine will have a negative effect on the cleaning results. 1. 2. 3.
Cleaning the spray arms Dirt or calcium residue may block the nozzles on the spray arms. For this reason, regularly check the spray nozzles. Cleaning the filter inset in the water inlet hose (depends on the model) Dirt from deposits in the water pipes is prevented by a filter in the water inlet hose. Check the filter and the water inlet from time to time. 1. 2. Lower spray arm Upper spray arm 1. 1. Remove the lower basket from the machine. Pull off the lower spray arm in an upward direction (A).
6 Troubleshooting: What to do if the dishwasher will not run • Check that the mains plug is properly connected. • Are all fuses working? • Is the water supply fully turned on? • Is the dishwasher door closed firmly? • Have you pressed the On/Off button? • Is the filter on the water intake and dishwasher clogged? The cleaning results are unsatisfactory 1033 Uncleaned Dishes Disorderly placement - Load your dishes as described in the manual.
Inadequate rinse aid - Increase rinse aid setting or add rinse aid into rinse aid compartment. Unsealed detergent dispenser lid - Always ensure that the detergent compartment lid is closed tightly after every detergent filling process. Drying Disorderly placement - Load your dishes as described in the manual. Inadequate rinse aid - Increase rinse aid setting or add rinse aid into rinse aid compartment.
1035 Lime Stains, Hazy Look Inadequate rinse aid - Increase rinse aid setting or add rinse aid into rinse aid compartment. Insufficient water softening - In products equipped with water softening setting, water softening should be properly set in accordance with the hardness of the supply water. Add salt into the salt container, if necessary. Salt leakage* - Use the supplied salt funnel while filling in softening salt. Make sure that the salt box cover is tightly closed after finishing the filling process.
1041 Scratch / Break In Glassware Kitchenware containing Aluminum - Kitchenware that contains aluminum should not be washed in dishwashers. Salt leakage* - Use the supplied salt funnel while filling in softening salt. Make sure that the salt box cover is tightly closed after finishing the filling process. Run a washing program to clean up the salts spilled in the machine. Recheck the salt box cover after the program is completed.
1038 Detergent Remains In The Detergent Dispenser Damp detergent compartment - Make sure that the detergent dispenser is well dried prior to filling it with detergent. Putting detergent in the detergent dispenser long before washing - Take care that detergent is put shortly before startup of washing. Blocking the opening of detergent dispenser lid dwing washing - Ensure that the lid of detergent dispenser is not blocked by improper loaded dishes.
Leaving the dishes in the dishwasher for a long time - If you are not going to run your dishwasher immediately, load the dishes into your machine after scraping the excessive soil on them and do not tightly close the door of the machine. Every other day, perform washing without detergent in the shortest program for products with program selecting feature. 1042 Foam Loading the dishes into the dishwasher without completely drying after washing them with hand-wash detergent.
Service If your appliance ever malfunctions, check the notes and advice given in the operating manual. If this does not fix the problem, our customer service staff are available to assist you.
GB 17 1388 01 00-AG
