Condenser drier with heat pump TKF 1350 S Operating instructions
Contents Dear customer, dear user of the Elektrabregenz-Dryer, Contents 2 Safety information 3 Disposal 3 Packaging materials 3 Old appliance 4 Conventional usage 4 Characteristics of your dryer 4 Operation mode of the condenser dryer with heat pump 4 Machine Overview 5 Installation 6 Proper location 6 Washer/dryer combination 6 Leveling of the dryer 6 Change of the hinge position 6 Connecting the drain hose 6 Electrical connection 7 Small introduction into textile lore 8 Labels and symbols 8 Drying progr
Safety information • In case of malfunctioning that cannot be repaired by following the instructions contained in this manual, please inform customer services. See chapter “Do it yourself, when…” In that case, turn the appliance off and pull the power plug. • Repair work on the dryer should only be undertaken by specialists and skilled personnel. Improper trouble shooting and other maintenance work can pose considerable risk to the user.
The plastic wrapping must not get into the hands of children! Risk of suffocation! Separate the packing material by type: • Styropor parts and plastic wrapping go to a valuable substance collection point • Battens go into bulky refuse. The packaging is not to be disposed of in the regular household refuse! • Display indicating the approximate program duration, i.e. remaining duration, delay timer and defect codes.
Machine Overview Display Program progress Indicator Leds indicator Program selector Time delay Water tank Start/Pause/Cancel Button Display On/ Off Switch Buzzer Cancel Button Electrical cable Type plate Fluff filter (in the door) Filter unit (behind the slit) Height adjustment feet 5 Water drain hose
Installation tomer service. Proper location Drain hose connection The water (condense water) accumulated during the drying process is caught in the water tank, which you have to empty after every drying. For drying the appliance requires a sufficient supply of fresh air. Install the dryer therefore in wellventilated, if possible, low-dust rooms only. The vent slots of the dryer must not be blocked nor covered. The appliance must not be installed in rooms at risk of frost.
2. Connect the drain hose securely to the water drain connection. 3. Lay and connect the drain hose to the drainage. 4. Secure the drain hose against slipping when hanging it over the sink or tub. Electrical connection Connect the dryer to a properly installed earthed outlet, protected by a fuse of adequate capacity. Important Advice • The connection must conform to the applicable regulations in your country and of your local Electricity Board. • The power cable plug must be accessible after installation.
Small introduction into textile lore Labels and symbols Care symbols: Check whether your textiles are suitable for drying. On the garment label, you find the following symbols: In principle, the drying in the condenser dryer with heat pump is possible.
Empty pockets and remove all foreign objects. Close zippers, hooks and eyes. Please note that the hinge position can be changed! See chapter “Change of the hinge position”. What must not be dried? You can also open the door during the drying operation to remove or add laundry. In order to do so, press button 1. “START/PAUSE/CANCEL” The drying operation will be interrupted. Open the door as described above. Remove laundry or add more laundry. Close the door and press the button “START/PAUSE/CANCEL” again.
Drying programmes cupboard dry and ironing dry 2. Easy-care: linen cupboard dry, ironing dry Turning the appliance on and off With the On/Off-switch, you switch the dryer on and off. Drying levels: Extra dry: thick, multi-layered textiles will be dried cupboard-ready. Start/Pause/Cancel button With the Start/Pause/Cancel button you start or interrupt the program to remove laundry, change the program group or end the program at an early stage.
wool and is also suitable for textiles with similar fabrics. Delicates: Gentle drying at low temperature with limited program duration. Textiles usually labeled “dry-cleaning” or “hand wash”, can be treated in the dryer with the help of new care-products. Airing / Refreshing: for white/colored cottons and easy-care textiles with normal loading.
Program charts Program group COTTON Care symbols Maximum load quantity 6 kg Program Textile type Examples of textiles EXTRA DRY thick or multi-layered textiles, that should be thoroughly dried Terry cloth laundry, bathrobes, bath towels LINEN CUPBOARD DRY textiles of even thickness, that should be thoroughly dried Terry cloth laundry, terry cloth towels, tricot laundry IRONING DRY cotton or linen laundry of normal thickness Bed clothes, table clothes Program group Easy-care Care symbols Maxim
Program Delicates Optional Functions This program permits the drying of very delicate laundry (e.g. sensitive underwear, microfibre, lycra). For additional protection of the textiles, it is recommended to dry them in a laundry bag. Buzzer cancel At the end of the program, an acoustic buzzer sounds. With the “Buzzer-Deselecting” button, you can mute the signal (also before the start of the program). The control indicator in the middle of the button will flash.
• Press the “+”-button to adjust the timedelay “1”, “2”, … until “19”, the “-“-button to reset from “19” to “1”. “Cool down”: - during the ca. 4-minute long cooling-down phase. “End / Anti-crease”: - during the anti-crease phase, until the program has ended. Important Advice 2. Press the button “Start/Pause/Cancel”, the appropriate control indicator flashes, the time-delay starts. 3. During the time-delay period more laundry can be added. After adding, the “Start/Pause/Cancel”-button must be pressed again.
or with a soft, dry cloth. 4. Insert the fluff filter the right way round. 3. Carefully remove the fluff balls around the fluff filter by hand or with a soft, dry cloth. 4. Open the sponge filter unit by pressing the red button The fluff filter/sponge filter unit Fluff balls, that are not retained by the main fluff filter, will be caught in the air tube by a second filter. This is made of a second fluff filter or a filter-mat made of sponge.
Notes on the positioning of the sponge filter After removal of the condenser- sponge filter, the metal grit structure of the heat exchanger becomes visible. After cleaning, the sponge filter should be reinserted without any squeezing. Reinsertion should be done as indicated by the arrow below. The condenser- sponge filter must be cleaned when covered with a layer of fluff. For that purpose, wash the filter and squeeze it until the sponge is only moist.
via the included drain hose (see “Connecting the drain hose”) Emptying the water tank: 1. Open the door and wait until the dryer has cooled down. 2. Wipe all drum ribs with a soft cloth moistened with vinegar. Dry them with a soft cloth. Important Advice Do not use solvents, naphtha or similar! Risk of fire or explosion! 1. Pull the water tank carefully out of the slit. Support the tank underneath with your second hand. 2. Open the latch of the water tank 3. Pour out the water 4.
Do it yourself, when… Problem The drying operation is taking exceptionally long Clean the fluff filter Clean filter unit The drying result is not satisfactory, the laundry is too wet Drum overloaded? Clean fluff filter and filter unit. Finish the drying with a suitable timed program.
Technical Specifications / Energy Consumption Load quantity (dry weight) White/colored cottons max. 6 kg Easy-care max. 3 kg Single piece max. 1 kg Airing / Refreshing max. 3 kg Wool / silk max. 1.5 kg / max 0.5 kg Delicates max. 4 garments Drying method Condensation, humidity controlled Dimensions Height / height for built-under installation 85.0 / 82/0 cm Width 59.8 cm Depth / depth for built-under installation 59.5 / 58 cm Depth with door open 90 degrees: 100.8 cm; 150 degrees: 81.
