Operating instructions

65
Installation
Proper location
For drying the appliance requires a
sufficient supply of fresh air.
Install the dryer therefore in well-
ventilated, if possible, low-dust
rooms only. The vent slots of the
dryer must not be blocked nor
covered.
The appliance must not be installed
in rooms at risk of frost. Some parts
of the appliance contain water and
can be damaged in the case of frost.
Ensure that the floor has a sufficient
load bearing capacity.
If a dryer is placed on top of a
washing machine, both appliances
together can weigh up to 150 kg
while loaded.
Important Advice
Place the appliance on an even and
level floor only.
Keep a distance of at least 1 cm to
walls and other furniture.
Washer/dryer combination
This dryer can be put on top of any
of our washing machines.
A special stacking kit is required
(Stock No. MBS 2000), available at
the customer service or specialized
trade.
Leveling
Adjust feet until the appliance
stands horizontally and firmly. Con-
trol with a water level.
Important advice:
Adjust by the feet only, do not use
wooden wedges or similar.
Do not remove the feet!
Changing hinge position
It is possible to change the hinge
position if it does not correspond to
local conditions.
If you wish to open the door to the
other side, you can have the hinge
position changed from left hand to
right and or vice versa by our cus-
tomer service.
Drain hose connection
The water (condense water) accumulated
during the drying process is caught in the
water tank, which you have to empty after
every drying.
You can also drain the water continuously
through the included drain hose by con-
necting it to a spout or other water drain-
age.
In that case you do not need to empty the
water tank after every drying cycle. The in-
dicator “Empty water tank” will nonetheless
flash at the end of every program.
Important Advice
The length of the hose and the highest
point over the floor have to be taken into
consideration for the draining of the water.
Install the hose without kinks!
Install as follows:
1. At the water drain connection, pull up the
condensate hose out of the appliance by
hand. Do not use pliers!