Operation Manual

14 - EN
Time delay
With the “Time delay” function you can
delay the program start up to 19 hours.
1. Opentheloadingdoorandputthe
laundry in.
2. Select the drying program and select
the auxiliary functions if required.
3. Press the “Time delay” buttons to
adjust the desired time.
4. Press “Start/Pause/Cancel” button.
The time delay function will start to
countdown.
C Additional laundry may be loaded
during the time delay period.
5. At the end of countdown process,
“:” will light up continuously and the
relevant program follow-up light will
light up according to the selected
program.
C During drying process, the display
shows the estimated time remaining for
the program to finish. The estimated
time displayed on the screen at the
beginning of the drying process
has been calculated on the basis
of an 800 rpm spin speed rate to
dry a maximum load capacity in the
washing machine.
C If the loaded laundry amount is less
than the calculated laundry amount or
if drying has been performed at higher
spin speed, the remaining time may
be less than the time that appears on
the display.
C Incase the laundry is spun at a lower
spin rate than the calculated one and
if “Filter Cleaning” or “Condenser
Cleaning” processes are not carried
out, the remaining time may be longer
than the time shown on the display.
C Dryness level of the laundry is
detected by sensors during a drying
cycle and the remaining time is
updated automatically.
Auxiliary function
Cancel Audio Warning
Yourmachinewillsendoutanaudio
warning when the program comes to
an end. If you do not want to hear this
buzzing, you need to press the “Cancel
Audio Warning” button. The relevant LED
will light up when this button is pressed
and an audio warning will not be given
when the program comes to an end.
C Youcanselectthisfunctioneither
before or after the program starts.
Warning indicators
Timer programming
A warning LED will light up when timer is
programmed.
Child-proof lock
A warning LED will light up as long as the
child-proof lock remains activated.
Filter cleaning
A warning LED will light up to remind filter
cleaning after the program finishes.
C If the filter cleaning warning lights up
continuously, please refer to, “Solution
suggestions for problems”.
Tank full
A warning LED will light up at the end
of the program or when the tank is full
with water. The machine stops operating
when this warning LED lights up during a
program running. To restart the machine,
please drain the water in the water tank.
Press "Start/Pause/Cancel" button to start
the program after you have emptied the
water tank. The warning LED goes off and
the program resumes operating.
Cleaning the condenser.
It will light up periodically after maximum 5
drying cycles for the purpose of reminding.
In this case and after drying, clean as
explained in the section “Maintenance and
Cleaning”.