Operation Manual

22
EN
2 Installation
Refer to the nearest Authorised Service Agent for
installation of your product.
C Preparation of location and electrical
installation for the product is under customer’s
responsibility.
BInstallation and electrical connections must be
carried out by a qualified personnel.
A Prior to installation, visually check if the
product has any defects on it. If so, do not
have it installed. Damaged products will cause
risks for your safety.
Appropriate installation location
• Install the product in an environment which
has no risk of freezing and is in a stable and
level position.
• Operate your product in a well ventilated,
dust-free environment.
• Do not block the air ducts in front of and
under the product with materials such as long
pile rugs and wooden bands.
• Do not place your product on a long pile rug
or on similar surfaces.
• Do not install the product behind a door with a
lock, sliding door or a hinged door which can
strike the product.
• Once the product is installed, it should stay at
the same place where its connections have
been made. When installing the product,
make sure that the rear wall of it does not
touch anywhere (tap, socket, etc.) and also
pay attention to install the product at a place
where it will stay permanently.
B Do not place the product on top of the power
cable.
• Keep at least 1.5 cm distance to walls of other
furniture.
Removing the transportation safety
assembly
ARemove the transportation safety assembly
before using the product for the first time.
1. Open the loading door.
2. There is a nylon bag inside the drum that
contains a piece of styrofoam. Hold it from its
section marked with XX.
3. Pull the nylon towards yourself and remove the
transportation safety assembly.
AMake sure that you have removed
the transportation safety assembly
(nylon+styrofoam pieces) before using the
product for the first time. Do not leave any
items inside the drum.
Under counter installation
• A special part (Part no. 297 360 0100)
replacing the top trim must be provided and
installed by the Authorised Service Agent in
order to use the machine under a counter or
in a cupboard. It should never be operated
without the top trim.
• Leave at least 3 cm of space between the side
and rear walls of the product and the walls
of the counter/cupboard when installing your
product under a counter or in a cupboard.
Mounting over a washing machine
• A fitting device should be used between
the two machines when installing above a
washing machine. The bracket (Part no. 297
720 0100 white/297 720 0200 grey) must be
installed by the Authorised Service Agent.
• Place the product on a firm floor. If it will be
placed on top of a washing machine, the
approximate weight of both machines may
reach 180 kg when they are full. Therefore, the
floor must be capable of carrying the load on
it!
Connection to water drain;
In products equipped with a condenser unit the
water accumulated during the drying cycle is
collected in the water tank. You should drain the
accumulated water after each washing cycle.
You can directly send the accumulated water out
through the water drain hose supplied with the
machine instead of periodically draining the water
collected in the water tank.
Connecting the water drain hose;