Operation Manual

32
EN
5 Maintenance and cleaning
Filter Cartridge / Door Inner Surface
Lint and fibres released from the laundry to the air
during the drying cycle are collected in the “Filter
Cartridge”.
C Such fibre and lint are generally formed during
wearing and washing.
C Always clean the filter and the inner surfaces
of the cover after each drying process.
C You can clean the filter and filter area by
vacuum cleaner.
To clean the filter:
1. Open the loading door.
2. Remove the cover filter by pulling it up and
open the filter.
3. Clean lint, fibre, and cotton raveling by hand
or with a soft piece of cloth.
4. Close the filter and place it back into its
seat.
C Clogging may arise on the filter surface after
using your machine for some time; if this
occurs, wash the filter with water and dry it
before using again.
C Clean the entire inner surface of the cover
and door gasket.
Sensor
There are humidity sensors in your dryer that detect
whether the laundry is dry or not.
To clean the sensor:
1. Open the loading door of the dryer.
2. Allow the machine to cool down if drying has
been carried out.
3. Wipe the metal sensors with a soft cloth,
dampened with vinegar and dry them.
C Clean metal sensors 4 times a year.
A Never use solvents, cleaning agents or
similar substances when cleaning since these
materials can cause fire and explosion!
Water tank;
The moisture in the damp laundry is taken from the
laundry and condens ed. Drain the water tank after
each drying cycle or during drying when “Water
tank” warning light turns on.
C You can use the water in the water tank in
your steam irons or air humidifiers.
A Condensed water is not drinkable!
A Never take out the water tank when the
programme is running!
If you forget to drain the water tank, your dryer will
stop during the following drying cycles when the
water tank is full and the “Water tank” warning light
will turn on. If this is the case, press the “Start/
Pause/Cancel” button to resume the drying cycle
after draining the water tank.
*To drain the water tank:
1-Pull the drawer and remove the water tank
carefully.
2-Drain the water in the tank