User Manual

60 / English
Front-Loading Automatic Washer
User maintenance instructions
3. Follow the below procedures in order to drain water.
Product has an emergency water draining hose, in order to
drain the water:
a Pulltheemergencydraininghoseoutfromitsseat
b Placealargecontainerattheendofthehose.Drainthewater
into the container by pulling out the plug at the end of the hose.
When the container is full, block the inlet of the hose by replacing
the plug. After the container is emptied, repeat the above
procedure to drain the water in the product completely.
c When draining the water is finished, close the end by the plug
again and fix the hose in place.
d Turn and remove the pump filter.
4. Clean any residues inside the filter as well as fibers, if any, around
the pump impeller region.
5. Replace the filter.
6. If the filter cap is composed of two pieces, close the filter cap by
pressing on the tab. If it is one piece, seat the tabs in the lower part
into place first, and then press the upper part to close.