User's Manual

P a g i n a | 5
MANUAL | yooBee Keyfob Tracker yB-010030-KT
3. Using the device
In operational mode, the tracker is active and connected to at least one and up to three yooBee
Hubs. It periodically broadcasts data from its inertial sensors, which is used in the Cloud
Console to track the position of the device.
If no movement was detected in the last 15 sec, the tracker goes into a sleep mode to preserve
battery life time. It is re-activated as soon as movement is detected.
In the background, the device runs protocols to establish and maintain connection with yooBee
Hubs in its proximity, and to roam between them.
4. Installation
The yooBee Keyfob tracker fits in a rubber band (yB-020031-KTR), such that it can be attached
to a key chain or a lanyard. Alternatively, a clip (yB-020032-KTC) can be used to clip the device
to a person or an asset. The device can also be glued to an asset, using double-side adhesive
tape, preferably on a flat and smooth surface.
5. Troubleshooting
The yooBee Keyfob Tracker has a multi-colored LED, that can be used for troubleshooting:
LED Code
Meaning
1x red short blink
Button press detected, tag unconnected
1 or more red short blinks
Button press detected, tag connected, and waiting TX
confirmation
1x green 10s after button press
Button press detected, tag connected, and received
TX confirmation
Series of short blue blink
Firmware update
1x red short blink after firmware update blue blinks
Firmware update failed
In case of possible malfunction, please contact technical support to receive proper
replacements (email: [e-mail]). Replacement policy also applies to performance
faults caused by low battery before certain operation time.
6. Disposal of the device
yooBee Keyfob Trackers contain electronic elements and batteries which should be properly
disposed and compliant to local regulations.
7. Safety Instructions
Opening yooBee Keyfob Trackers is strictly forbidden. Switching the original battery with one
of a different type might cause a risk of explosion.