- BLOOMFIELD INDUSTRIES LX AIRPOT & THERMAL BREWERS OWNERS MANUAL INSTALLATION OPERATION USE & CARE SERVICE 2280, 2282, 2286EX, 2288EX

OPERATION

SEE PAGE 13 FOR COMPONENT NAMES/NUMBERS

1. Water enters at the inlet fitting of the fill solenoid (32). The

solenoid admits water via a command from the controller.

NOTE: The solenoid has an internal strainer. To clean the

strainer: Shut off water supply. Unscrew the plastic cap

protruding from the rear of the brewer. Remove the cap,

inlet fitting and washer. With pliers, grasp the bar of the

strainer and pull straight out. Wash any debris from the

strainer. Note orientation - DO NOT reverse strainer.

Reassemble and reinstall. Turn water supply back on.

2. Water enters the tank (2) thru the fill tube (16). Water is

heated in the tank by the heating element (15).

3. The tank lid (9) is sealed around the edge with a gasket

(6), and is secured by 3 clips (10).

4. Heated water is dispensed to the brew head through the

brew tube (14), brew solenoid (18), and spout of the brew

fitting (19). The brew solenoid is energized during the brew

cycle by the controller.

NOTE: The flow rate of the brew solenoid is factory set.

DO NOT adjust.

5. Hot water is sprayed over the coffee grounds by the spray

disc (24), which is sealed to the brew head by a gasket (23).

6. The tank is vented through the vent fitting (40) and vent

tubes (12 & 13).

7. Water for the hot water faucet (22) is supplied from the tank

through the faucet supply tube (11).

SOLENOID

STRAINER

WASHER

INLET

FITTING

CAP

(note orientation

DO NOT REVERSE)

FILL

SOLENOID

FLOW

CONTROL

(

installed)

LID

TANK

GASKET

CLIP

LID GASKET

SERVICING INSTRUCTIONS — PLUMBING