Specifications

TROUBLESHOOTING SUGGESTIONS

606 Owners Manual for 8742-8748 Tea Brewer 2M-76116

SYMPTOM POSSIBLE CAUSE SUGGESTED REMEDY

Water won’t heat

Brewer unplugged or circuit breaker

tripped

Check power supply cord

Check / reset circuit breaker

Temperature setpoint too low Set for desired temperature

Hi-Limit safety switch tripped Allow to cool hi-limit will self-reset

Damaged internal component or wiring

Examine wiring & connectors, controller, power

board and heating element, Repair/replace as

needed

Tea level too high or low Timer out of adjustment Adjust timer

Brew chamber overows

Too many lter papers or wrong lter

paper

Use one (1) genuine Bloomeld lter per brew

Brew chamber dispense hole plugged Thoroughly clean brew chamber

Too much tea leaves Use correct amount of tea

Sprays water from brew

head

Spray gasket improperly installed Check/reinstall gasket on INSIDE of brew head

No brew

Spray disk plugged Clean spray disk

Damaged internal component or wiring

Check switches, timer and solenoid. Repair,

replace as needed

Water supply OFF Turn water supply ON

“Y” Strainer or solenoid inlet strainer

plugged

Clean strainer

Water lter (if used) plugged Replace lter element

Poor tea quality

Keep brewer and dispenser clean.Install a taste and odor lter in water supply, and replace

cartridges regularly. Use a quality fresh supply of tea leaves. Use the amount of tea leaves

appropriate to brew volume. The needle valve adjusts the ratio of brew water to dilution

water. Set the needle valve to adjust the strength of the nal brew.