Owner`s manual

TROUBLESHOOTING
[ PROBLEM ][ PROBABLE CAUSE]
CORRECTIVE ACTION
I‘
Quality light lo not
on/flashing when
Satellite is in place.
Satellite Receptical or SDS-l
Connector
Check Receptical and Connector Assembly, make sure all pins are
tight and in place.
Check ail soldered wiring. ~
Check continuity, replace if defective.
Snap Action Switch in Connector Check continuity, replace if defective.
Satellite is not in proper position
Place Satellite unit in proper position, making sure the, bottom dimples
on Satellite base are located on the matching dimples on the Brewer.
Quality light stays
on when Satellite is
not in place.
Snap Action Switch Snap Action switch on Connector should open when Satellite is
removed from position, shutting off the light. if not, replace Switch.
Quality light flashes
constantly
Satellite is still in place
Satellite was in place when
timer initialized
Quality Timer
Remove Satellite for more than 4 seconds for timer to reset.
Remove Satellite, Unplug unit for more than 4 seconds. Plug unit in
(with Satellite removed)
Remove Satellite, Unplug unit for more than 4 seconds. Plug unit in
(with Satellite removed) If unit still flashes, replace Quality timer.
11