Owner`s manual
INSTALLATION INSTRUCTION
READ THIS COMPLETELY BEFORE STARTING THE INSTALLATION `-
!
CAUTION:
DO NOT plug in or energize this unlt until lnstallation Instructions are read
and followed.
Damage to the Unit
will
occur If the Instructions are not followed.
To enable the installer to make a quality installation and hold delay time to a minimum,
the following suggestions and tests should be done before the actual unit installation is
begun.
LEVELING THE UNIT
:
Set Satellite Docking Station in operating location and level.
For proper unit operation,
It is very important that the
unit
be level when It Is standing In Its proper operating
position.
A spirit level should be place on the top plate of the unit, at the edge, as a
guide when making level adjustments.
Level the unit from left to right and front to back
by turning the adjustable feet that support the unit.
!
CAUTION:
Rubber feet must be Installed on each leg of the unit. Failure to do so
will
result In movement of the Satellite
Docking
Station
which
can cause personal
Injury and/or damage to unlt.
ELECTRICIAN’S INSTALLATION INSTRUCTIONS
!
WARNING ELECTRICAL SHOCK HAZARD:
Satellite Docking Station must be properly
grounded to prevent possible shock hazard.
Electrlcal
shock
will
cause death or
serious Injury.
The unit requires a dedicated power source capable of supplying: 120 Volt, A.C. (3) wire,
15 Amp Service.
The unit is shipped from the factory with a power cord.
INITIAL INSTALLATION INSTRUCTIONS
A
CAUTION:
lnitial lnstallatlon should be performed by a qualified Installer or qualified
service technician.
Improper Installation
will
damage the Satellite Docking Station.
Be sure all electrical connections are secure.
Plug in Satellite Docking Station
NOTE:
Satellite Light will flash momentarily to initialize the timer when initially plugged
into electrical outlet. DO NOT plug in unit when Satellite is in place.
This will cause light
to flash constantly.
Position Satellite onto the Satellite Docking Station to insure light
is
on (there may be
a slight delay before light comes on in some models)
The Light will start flashing after the preset time is reached.
See Satellite Operation Section
in the SS1 Instruction Manual for more information.
6