Owner`s manual

QUALITY TIMER ADJUSTMENT INSTRUCTIONS

Flashing light timer is preset from the factory for 30 minutes.

To increase the holding time:

ELECTRICAL SHOCK HAZARD: Disconnect power supply to Unit before removal of any

panel or replacement of any component.

Electrical shock will cause death or serious

injury.

CAUTION: All adjustments should be made by a authorized Bloomfield Service Technician

1. Unplug unit from the electrical outlet.

Timer Adjustment

2. Remove Rear panel. (See item 5 on page 8)

3. Locate time control (See item 13 on page 8) and turn

clockwise to holding time maximum. (See Figure

NOTE:

Maximum allowable time is 120 minutes.

4. Replace Rear Panel.

5. Plug unit in.

Figure 1

NOTE:

When light is flashing, Satellite unit will maintain temperature until the Satellite

is removed from the Docking Station, Satellite must be removed for more than 4 seconds for

the Timer to reset.

There is no power supplied to the satellite unless the Satellite is in place on the Unit

and the light is on.