Installation & Assembly

ManualsBrandsBloomsbury Market ManualsCeiling LightsCapri 1 - Light Single Cone Pendant

Mounting strap Mounting Screw Mounting screw

1ea 4" 2ea 8/32"X28mm 2ea 8/32X1"

Wire connnector Hex Nut

Deco nut

(round

nut)

3ea P4 Orange 2ea 8/32"X3.5mm 2ea @12mm

Canopy Rod Rod

1ea 130 Dia*H70mm 3ea 12.7mmDia* H12“ 1ea 12.7mmDia* H6”

Part Needed Quantity

Reason why ( missing, scratched, broken glass, bent, bad finish)

Comments

For Customer Service, contact the place of purchase to arrange for replacement parts.

IXTURE

SSEMBLY

NSTRUCTIONS

Read and review installation instruction sheet before

assembling the fixture.

1. By measuring determine correct number of rods needed

for proper hanging height.

* This fixture includes 4 rods (6", 12", 12", 12")

2. To shorten the fixture; slide the excess rods off the

wires. To lengthen add additional rods.

3. Pull the fixture’s wires through the rods (H,I,J,K) until

taut and thread the rods together. Then thread to the

fixture body (L) and the swivel joint on Canopy (G).

4. Slide the glass shade (M) over Socket of fixture body

(L)and secure it by threading the Socket ring (N) on until

tight.

5. Install the light bulb in accordance with the fixture's

specification.

(DO NOT EXCEED THE MAXIMUM WATTAGE RATING)

Fig. 1

NOTE: INSTALL THE GLASS ASSEMBLY

AFTER THE FIXTURE IS HUNG.

PARTS & ASSEMBLY SHEET

This fixture assembled PO:__________ Date: ________

Notice:

Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or

damaged, please note on this sheet and contact the place of purchase to arrange for replacement parts.

PARTS LIST

Company Name:_______________________Co. Account #:_____________

below to be filled out by retailer

These three

rods may be

removed.

Bulb (Not provided)

Fixture Name:

Summary of content (2 pages)

PAGE 1
PARTS & ASSEMBLY SHEET Fixture Name: This fixture assembled PO:__________ Date: ________ Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or damaged, please note on this sheet and contact the place of purchase to arrange for replacement parts. PARTS LIST Company Name:_______________________Co.
PAGE 2
INSTALLATION INSTRUCTIONS Fixture Name: For Pendant Light Fixture WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER. HANGING THE FIXTURE (Fig. 1) 1. Carefully remove the new fixture from the carton and the yellow bag that holes all your parts. Check that all parts are included as shown in the illustration and parts list. Fig. 1 2. Shut off power at the circuit breaker and remove the old fixture from wall, including the old mounting strap. 3.