Assembly Instructions

Table Of Contents

Canopy Wire Connectors Top Loop

1ea @5-1/2"X1-1/2" 3ea P4 Orange 1ea 90 x 98mm

Chain

Junction Box

Screw

Spring Washer

1ea 6ft x4.2mm 2ea 8/32" x 1" 1ea @15 x 2mm

Chain Connector Nipple

2ea @4.2X50mm 1ea @3/8 x 40mm x 5mm 1ea @3/8 x 65mm

Mounting Strap

w/ ground screw

Hex Nut

1ea 3/4"X4" 2ea @3/8 x 3mm 3ea

Part Needed Quantity

Reason why ( missing, scratched, broken glass, bent, bad finish)

Comments

Fig. 1

For Customer Service, contact the place of purchase to arrange for replacement parts.

PARTS & ASSEMBLY SHEET

Read and review installation instruction sheet before

assembling the fixture.

FIXTURE ASSEMBLY INSTRUCTIONS

This fixture assembled PO:__________ Date: ________

Canopy Loop

with Collar

ASSEMBLING THE FIXTURE (Fig. 1)

1. Attach both ends of support chain (N) to the hooks of top

loop (J) and hooks of fixture body (M) metal curl as shown

in the diagram.

2. Feed the fixture wires through the Top loop (J) and pull

the wires until taut.

Notice:

Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or

damaged, please note on this sheet and contact the place of purchase to arrange for replacement parts.

PARTS LIST

Company Name:_______________________Co. Account #:_____________

to be filled out by retailer

Decorative Chain

(support)

Bulb

(Not Provided)

PAGE 1
PARTS & ASSEMBLY SHEET This fixture assembled PO:__________ Date: ________ Notice: Please review the parts listing and check for all parts before assembling the fixture. If any parts are missing or damaged, please note on this sheet and contact the place of purchase to arrange for replacement parts. PARTS LIST Company Name:_______________________Co.
PAGE 2
PARTS & ASSEMBLY SHEET ASSEMBLING THE FIXTURE (Fig. 2) Fig. 2 4. By measuring determine correct number of links needed for proper hanging height. Use a pair of pliers to open one link of the Chain (K) then remove the excess Chain (K) and discard it. D C 5. Use one chain connector (L) to attach one end of the chain to the Top loop (J) and close the chain connector. 6. Feed the fixture wires through the Chain (every three links) and pull the wires until taut. 7.
PAGE 3
INSTALLATION INSTRUCTIONS For Chandelier Light Fixture WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER. HANGING THE FIXTURE (Fig. 1) 1. Carefully remove the new fixture from the carton and the yellow bag that holds all parts. Check that all parts are included as shown in the illustration and parts list. Fig. 1 JUNCTION BOX (CEILING) 2. Shut off the power at the circuit breaker and remove old fixture from ceiling, including the old mounting strap. 3. Thread Nipple(C) into Canopy Loop (F) until snug.