Installation & Assembly

Pendant Lamp Assembly Instructions
1. Please open the carton carefully and take out of all the parts and place it
to a soft floor.
2. Please find your room plafond place for assembling the pendant lamp,
There is a hole with your room 2 wires, then drill 2 small holes with the
same distance of 2 holes ③ of the metal part.
3. Insert the plastic parts ② into the holes, stable the metal part by its 2
holes with the 2 screws ②
4) take the upper sockets clusters out and pass its wire through its upper
Metal clusters and its metal parts and it’s chains and it’s tube with
Canopy ④ then connect the wire to the wire center.
5. Make wire ⑦ go through lampshade center and connect with ⑧ and
make the wire go through the chain till the top of cover.
6. Connect the metal part screw with the tube then connect your Room wire
with from hole to the wire center with parts of .①
7. Put the canopy up to the plat fond and stable it by the small screw.
8. Assemble your bulbs in the sockets of the lamp, bulbs are not included.
9. Turn on/off your room electric outlet for the pendant lamp, OK.
10. You can reduce the pendant lamp total height by shorter the chains
length just cut offer its several chain parts and find a suitable height for your
home decoration, Normally our size are ok for normal height.
Pendant Lamp Assembly Instructions
1. Please open the carton carefully and take out of all the parts and place it
to a soft floor.
2. Please find your room plafond place for assembling the pendant lamp,
There is a hole with your room 2 wires, then drill 2 small holes with the
same distance of 2 holes ③ of the metal part.
3. Insert the plastic parts ② into the holes, stable the metal part by its 2
holes with the 2 screws ②
4) take the upper sockets clusters out and pass its wire through its upper
Metal clusters and its metal parts and it’s chains and it’s tube with
Canopy ④ then connect the wire to the wire center.
5. Make wire ⑦ go through lampshade center and connect with ⑧ and
make the wire go through the chain till the top of cover.
6. Connect the metal part screw with the tube then connect your Room wire
with from hole to the wire center with parts of .①
7. Put the canopy up to the plat fond and stable it by the small screw.
8. Assemble your bulbs in the sockets of the lamp, bulbs are not included.
9. Turn on/off your room electric outlet for the pendant lamp, OK.
10. You can reduce the pendant lamp total height by shorter the chains
length just cut offer its several chain parts and find a suitable height for your
home decoration, Normally our size are ok for normal height.