Operator`s manual
© 2009 ICS, Blount Inc. F/N 70944 Oct 09
TITLE 633GC / 633F4 OPERATOR’S MANUAL
18
AIR FILTER
The air filter is made from a nylon micro mesh air filter and an
internal spit-back screen. Both must be kept clean for the engine
to operate properly. If the saw is not reaching full RPM, most
likely one or both of the air filters are dirty.
IMPORTANT
• Theairfilter(Figure1)shouldbefreeofholesandwhitein
color.
• Replaceairfilterwhendirty.
• Thespit-backscreen(Figure2)shouldbefreeofholesandbe
white in color. Clean with mild solvent or gasoline and dry with
highpressureair.Ifspit-backscreenisdirtythesawwillnot
reachfullRPM.
• Duringre-assembly,tightenairfilterwing-nut"fingertight"plus
an 1/8" of a turn with wrench.
STARTER HOUSING ASSEMBLY
It is common for concrete slurry to get inside the starter housing
assembly during cutting. This can cause the starter pawls to stick
and not engage when the rope is pulled.
IMPORTANT
• Aftereachusage,thoroughlyflushthestarterhousing
assembly with water.
• Oiltherecoilspringbysprayinglightweightoilintotheport
(Figure3).
• Oilthestarterpawlsbysprayinglightweightoilintothestarter
housing through the vents.
• Checkthestartercordforfraying,replaceifnecessary.
Figure 1
Figure 3
Figure 2
MAINTENANCE
Oil port