User Guide

BlueParrott B550-XT User Guide
PAGE 14
ADVANCED FEATURES AND FUNCTIONS (continued)
Proximity Pairing
Proximity Pairing is an alternative method of pairing where the headset initiates
the pairing process instead of your phone.
1. Make sure the headset is powered on and not connected to another device.
2. Set your phone so it is “discoverable,” or visible to other devices.
3. Quickly press the MFB and the Volume Down button,
if headset is not already in pair mode.
4. You should hear the voice prompt “pair mode” in the headset.
5. The headset lights should now be alternating red and blue.
6. The headset initiates pairing activity, and the incoming pairing request must
be accepted on the phone. NOTE: This may include entering the pin number
“0000” (four zeros).
Additional Features and Functions
Last Number Redial
By Voice:
You can use voice commands to dial both the last outgoing and last incoming
call.
• To redial the last outgoing call, activate voice command and say “redial.”
• To call back the last incoming call, activate voice command and say “callback.”
Using Buttons:
To redial the last outgoing call that was dialed from the cell phone, press and
hold the Volume Down button for approximately 1 second. A beep will be heard
and the phone will redial the last number.
Call Waiting/Rejecting a Call
If you are on an active call and a second call comes in, you will hear a low tone
notification in the headset. Where supported by your phone, you can either
accept the incoming call and end the active call, accept the incoming call and
place the active call on hold, or reject the incoming call and continue the active
call.
• To accept the incoming call and end the active call, press the MFB
once to end, and then press it once again to answer.
• To accept the incoming call and place the active call on hold,
quickly press the MFB twice.
• To reject the incoming call, press and hold the MFB for 1-2 seconds.