Owners Manual

input matches the type of cartridge being used. The factory installed cartridge is 47k

ohms / MM-input.

To connect a Blue Aura v40 amplifier to the turntable using Bluetooth, turn the v40

on and change the Source to BT (ensure BT antenna is connected to the back of the

v40)

Using the v40 remote control, press the BT button to put into pairing mode – fast

flashing.

Turn the PG1 turntable on and it automatically searches for any BT devices that are

in search mode – flashing LED, rear of turntable.

Once connected, the blue led on the v40 and the turntable changes to solid blue – no

flashing.

NOTE: If your amplifier does not have an input suitable for phono cartridges please

refer to Stereo System Connection.

Stereo System Connection

Set the PHONO & Line Out Switch on LINE mode. The RCA PHONO & Line Out

Jacks output analog line-level signals and can be connected to a suitable amplifier

(v40), or a pair of active/ powered speakers.

The Red plug connects with the Right channel and the White plug connects with the

Left channel.

NOTE: The RCA Jacks are not designed to be connected directly to the passive/

unpowered speakers on LINE mode. If connected to the passive speakers, no

sound will come out.

Main Power Connection

The power adapter is in the foam packing material. Unpack the power adapter and

plug the small end into the DC power jack located at the back side of the turntable.

Plug the power adapter into your power outlet.

Remark: Due to the Erp stage 2 requirements for power saving measures, a unit