Operating instructions

14
Wireless Status
Before turning on your
WS90t
loudspeakers, locate the ZONE setting switch on the rear of each loudspeaker and set to A
The system has three channels: Blue (default) Red and Green. The loudspeakers and Transmitter are connected wirelessly when they are
both operating on the same channel, Blue, Red or Green.
Transmitter
Connect the Transmitter to your source device
Transmitter mode - LED ashing
Loudspeakers
Turn on both Left and Right loudspeakers with the switch located on the back of each loudspeaker. The LEDs will ash
for 6 seconds and the loudspeakers will go into standby. Using the remote control, press the POWER ON button and the
loudspeakers will come out of standby and automatically search for the signal from the transmitter, once found it will
lock and sound will be heard. If the loudspeaker is already using the same channel as the transmitter, sound will be heard
instantly.
▪ Loudspeaker LEDS will automatically turn off 10secs after last command.
▪ Volume memory. When the loudspeaker is brought out of Standby, the volume will be at the same level as last set.
▪ Channel memory. When the loudspeaker is brought out of standby the channel will be the same as last set.
▪ To return the loudspeaker to default mode, press and hold the STATION button on the rear of each loudspeaker for 8
seconds. Default channel is Blue, Default volume is 40 on a scale of 1 – 70