User's Manual

can be fully charged about 5 hours. Then the Tri-color LED will turn blue.
2.5 SAM Card Installation
When you first receive the CT100 terminal, you may need to install a Secure Access Module (SAM) card. The
following procedure describes SAM card installation:
a. Turn the terminal over. Remove the set screws and the cover. The SAM slot is located beneath the
battery, as seen in Figure 7
b. Insert the SAM card in the slots with the electronic chip facing down and the cut-out corner on the
bottom. (Figure 8)
c. Place the cover and insert the set screws
(Figure 7)
(Figure 8) Insert SAM card
CAUTION:
Observe standard precautions for handling electrostatic sensitive devices.
Electrostatic discharges can damage this equipment. Wearing an anti-static wrist strap grounded to a metal
surface is recommended.
SAM slots