Instructions / Assembly

Temperature Ratings:
Minimum: 32º F / 0º C
Maximum: 125º F / 51.6º C
Angle Valve
Installation
Straight Valve
Installation
Canterbury Enterprises
Log Lighter Gas Ball Valve Installation Instructions
Installation Notes
Log Lighter Valve
1 Turn off the gas line to the firebox or, if necessary, the main gas line
2 Determine which side of the firebox the valve will be installed.
Drill a 1¼” hole for the flange and valve. Thread the valve into
the flange from below the floor or behind the wall.
3 Run ¾” gas pipe from the valve and extend approximately
3½” into the firebox if comimng from the side, or 1½” if coming
from below. Cap off firebox stub with threaded ¾” cap.
4 Run ¾” gas pipe from the gas source to a ¾” lever-type ball valve.
5 Run ¾” gas pipe from the lever-type ball valve to a ¾” gas pipe union.
6 Run ¾” gas pipe from the valve to the union and thread the union together.
Test all new connections with a liquid leak detector.
¾" pipe union
¾" gas pipe
¾" gas pipe
to
reb
ange
valve
1¼" hole
¾" gas pipe
¾" gas pipe
to gas source
lever-type valve
¾
" pipe union
¾
" gas pipe
¾
" gas pipe
to rebox
ange
valve
1¼" hole
¾
" gas pipe
¾
" gas pipe
to gas sourc
lever-type valve
•
For use with natural gas and LP gas only.
•
Always follow ALL local building and plumbing codes during installation.
•
Use only black gas pipe and secure piping every five feet or less.
•
Remove any debris from male and female threads before connecting.
•
Always use a pipe joint compound or P.T.F.E. pipe thread tape on all
connections to seal threads.
1-800-321-6566 • www.blueflamestore.com