User guide

6
Type 1 Meter: Electromechanical
1
Open the Sensor Arm latch
G
by pulling upward.
2
Extend the Sensor Arm
B
to its full length by pulling
on it firmly, but gently. If you accidentally pull it out
completely, push it back into the casing.
3
Close the latch
G
.
Type 2 Meter: Electronic with optical
port on the face, 1.5 inches or more from
the outer rim
1
Open the Sensor Arm latch
G
by pulling upward.
2
Ensure that the Sensor Arm
B
is pushed in as far
as it will go into the body of the Sensor Unit.
3
Close the latch
G
.
Type 4 Meter: Electronic - optical port on top
1
Open the Sensor Arm latch
G
by pulling upward.
2
Gently pull the Sensor Arm
B
completely out of the Sensor Body.
3
Turn over the Sensor Arm
B
.
4
Push the thin end of the Sensor Arm
B
upwards through the latch opening and press
the Sensor Arm firmly into the cavity.
5
Firmly push the Sensor Head
C
behind the strap, and as far down as it will go into the
bottom cavity of the body. The dark red Sensor Head LED
D
must be clearly visible
below the clamp. If necessary, use a dull pointed object, such as a ballpoint pen to push
the head
C
downwards.
6
Tuck the wire
E
into the side cavity
F
.
7
Close the latch
G
.
A
B
C
D
E
F
G
Type 3 Meter: Electronic with optical port on the face, 1.5 inches
maximum from the outer rim
1
Verify that the Sensor Arm
B
is fully pushed in as described for Type 2 meters.
2
Peel off the adhesive backing from the shim.
3
Position the shim on the underside of the Sensor Unit casing with the adhesive side down.
4
Press the shim in place onto the underside of the Sensor Unit casing.
4
Clamp
Sensor Arm (pulled out)
Sensor Head
Sensor LEDs (dark red
and white)
Wire
Wire Cavity
Sensor Arm Latch
Instructions: Perform the operations in the block that corresponds to your meter
type. When you are done, go to Step 9 - Install your Sensor Unit.
A
B
C
D
E
F
G
Prepare Your Sensor Unit
8