User guide

8
Synchronize Your Sensor and Display Units
10
Finalize the Installation
11
1. Press and hold the PROG/SYNC
button until the Display Unit
beeps twice (about 5 seconds)
and displays the ID screen.
2. Press and release the RESET
button on the battery cover of the
Sensor Unit. The Display Unit now
displays the Startup screen.
Your Display Unit should start
displaying real-time information
within a few minutes.
1. Tighten the hose clamp
A
just enough so that the Sensor Unit cannot move.
2. Turn off the appliance you turned on when you started.
Your Sensor Unit should now be correctly installed and communicating
with your Display Unit.
If there is a problem, please read the Troubleshooting section in the
User Guide.
$
TIER 1
PM
SUN
TOTAL
$
$
TIER 1
PM
SUN
TOTAL
Technical Specifications
FCC INFORMATION
FCC Class B Part 15
This device complies with part 15 of the FCC Rules.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guar-
antee that interference will not occur in a particular installation. If this equip-
ment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
s 2EORIENTORRELOCATETHERECEIVINGANTENNA
s )NCREASETHESEPARATIONBETWEENTHEEQUIPMENTANDRECEIVER
s #ONNECTTHEEQUIPMENTINTOANOUTLETONACIRCUITDIFFERENTFROMTHAT
to which the receiver is connected.
s #ONSULTTHEDEALERORANEXPERIENCEDRADIO46TECHNICIANFORHELP
Industry Canada Certification
Operation is subject to the following two conditions:
s 4HISDEVICEMAYNOTCAUSEHARMFULINTERFERENCEAND
s 4HISDEVICEMUSTACCEPTANYINTERFERENCERECEIVEDINCLUDINGINTERFERENCE
that may cause undesired operation.
© 2008. Blue Line Innovations Incorporated. All
rights reserved. Information in this document
is subject to change without notice. Blue Line
Innovations and PowerCost Monitor are trade-
marks of Blue Line Innovations Incorporated.
All other trademarks are the property of their
respective owners.
Printed in China BLI-00301R001
PROG/SYNC
ID Screen
Startup Screen
Power
Display Unit 2 AA Alkaline Batteries (LR6 or equivalent)
Sensor Unit 2 AA Alkaline Batteries (LR6 or equivalent)
2 AA Lithium Batteries for temperatures consistently below -20 ºC
Wireless Communications
Frequency 433.92MHz
Update Rate Approximately every 30 seconds
Range Up to 30m (100ft.) line-of-sight (Subtract 5m or 15 feet
for each wall between Display and Sensor Units)
Operating Temperature Range
Display Unit 10°C to 40°C (50°F to 104°F). For indoor use only
Sensor Unit -40°C to 60°C (-40°F to 140°F)
Altitude
Display Unit 2,000 meters maximum
Relative Humidity
Display Unit 80% for temperatures up to 31°C decreasing linearly to 50% at 40°C
Pollution
Display Unit Pollution Degree 2
Blue Line Innovations Inc.
187 Kenmount Road
1st Floor, ICON Building
St. John’s, NL Canada, A1B 3P9
[e-mail]
www.bluelineinnovations.com
Toll Free: 1-866-607-2583