Full Product Manual
chain can be lifted by approximately 2 - 4 mm from the guide bar (8) in the
centre (Figs. 11, 12).
Fig. 11 Fig. 12
2. Adjust the tension if you find that the chain saw is too loose or tight.
3. Chain lubrication
WARNING! The product is not filled with chain oil. It is essential to
fill the product with chain oil before using it! Never operate the
product without chain oil as this will result in extensive damage to
the product!
Operating the saw chain dry or with too little chain oil will decrease
cutting efficiency, shorten the product life span and cause rapid
wear to the saw chain and guide bar from overheating!
Insufficient chain oil is evident by smoke or bar discoloration!
Adequate lubrication of the saw chain during cutting operations is
essential to minimise friction with the guide bar!
1. Place the product on a stable, level surface with the chain oil tank cap (29)
facing upward. We recommend laying a non-flammable sheet under the
product.
2. Unscrew and remove the oil tank cap (29) (Fig. 13).
Fig. 13
29
32
1-800-348-5004
DVTUPNFSTFSWJDF!GPDVTPOUPPMTDPN
28