Instructions / Assembly

Note: There are three sizes of hex bolts. Make sure you’re
using the type specified in each step. Do not fully tighten
the bolts until you’ve completed the assembly and
checked to see if the alignment is correct.
Step 1
Place the table top (C) and table leg (A) on a soft,
non-abrasive surface such as cardboard or a blanket.
Step 2
See Figure 1. Use the wrench (GG) to attach the table
legs (A) to the table top (C) with 8 M8x40 bolts (BB),
M8 washers (EE) and lock washers (DD).
Step 3
See Figure 2. Use the wrench (GG) to attach
connectors (B) to the table legs (A) with 4 M8x20
bolts (AA), M8 washers (EE) and lock washers (DD).
A
A
C
A
C
EE
DD
BB
Figure 1
Assembly Instructions
Take a deep breath and keep a clear spot nearby
where you can place the small pieces.