SAYLOR Dining TABLE ASSEMBLY instructions
Before You Begin: You already know this, but it’s best to read ALL the instructions before assembly. Failure to do so may result in faulty assembly and potential injury ( no one wants that kind of stain on their party hosting record). Assemble your Blue Oak™ outdoor furniture on a soft, non-abrasive surface such as a carpet or cardboard to avoid damaging the item. Seek assistance to assemble bulky or heavy items (there’s no “i” in “team”).
PARTS NO. DESCRIPTION QTY A Table Leg 1 B Leg Connector 1 C Table Base 1 D Table Top 1 E Umbrella Cap 1 HARDWARE NO.
Assembly Instructions Take a deep breath and keep a clear spot nearby where you can place the small pieces. Note: There are two sizes of hex bolts. Make sure you’re using the type specified in each step. Do not fully tighten the bolts until you’ve completed the assembly and checked to see if the alignment is correct. Step 1 See Figure 1. Place leg connector (B) across and into table leg (A). A B Step 2 Figure 1 See Figure 2.
Step 3 See Figure 3. Use the wrench (FF) to attach the assembled table base to the table top (D) with 4 M8x20 bolts (BB), M8 washers (DD) and lock washers (CC). C BB A CC B A DD D D Figure 3 Step 4 Fully tighten all bolts and apply the bolt head caps (EE) on to each bolt. Step 5 See Figure 4. Use the umbrella screw to tighten the umbrella if necessary. If the table is used without an umbrella, use the umbrella cap (E) to cover the umbrella hole. E B Figure 4 your table is complete.
blueoakoutdoor.