User's Manual
Table Of Contents
- QuikCall Pagers Cover Page 321045
- Introduction
- Pager C ertifications
- Pager Dimensions and Weights
- Charger Dimensions and Weights
- Charger Components
- Connecting Power
- Mounting Chargers
- Combining Chargers
- Charging and Storing Pagers
- Paging Using a Desktop Controller
- Paging Using a Kitchen Controller or Expeditor Panel
- Paging Using a Desktop Controller and Telephone
- Replacing the Clip
- Replacing the Insert
- Insert Dimensions
- Replacing the Battery
- System Warranty - Back Page
5
Combining Chargers:
If two Chargers are to be used, they can be
combined with one 2.4A Power Supply.
To combine:
1. Use a screwdriver or similar tool to extend
the metal tabs out from one of the
Chargers.
2. Place both Chargers on a table and slide
together. The metal tabs will lock both
Chargers together.
3. Insert the Power Adapter plug into jack on the
bottom of the Charger.
4. Use the Jumper Wire (optional) to
connect both Chargers together.
5. Feed the wires through the guides
in the bottom of the Charger.
6. Connect the Power Adapter to
the AC Power Cord.
7. Plug the AC Power Cord into a
110-240AC outlet.
8. The green LED on the Charger will
light (ON).
9. Once the Charger is
powered (ON), the Pagers
can be inserted.
Combining Chargers
Power
Adapter
Plug
Charger
Jack