User's Manual

8
Paging Using a Kitchen Controller or Expeditor Panel:
1. Remove the Pager you wish to
page from the Charger.
2. The Pager will flash and vibrate
to confirm it is ready for use.
3. The Pager charge LED will continue to flash, confirming it is
ready to receive a page.
4. Press the number on the Controller or Expeditor Panel of the
Pager.
5. The light on the panel, next to that number will
turn ON.
6. The XMIT light will turn ON for 2-3 seconds and turn off.
7. The Pager will receive a single, one second vibration
(factory setting).
8. The light on the panel, next to that Pager number will
continue to stay ON for 40 seconds (factory setting).
9. If a Controller and Expeditor Panel are combined,
pressing a button on either panel will light both panels.
10. After 40 seconds (factory setting), the light next to the
number pressed will begin to blink on the Panel or
Panels for an additional 40 seconds (factory
setting), before turning off.
11. See Paging instructions in your Kitchen
Controller manual for more information.
Paging Using a Kitchen Controller or Expeditor Panel