User's Manual

6
Charging Pagers:
 Pagers are turned OFF during shipment from JTECH.
 When first received, Pagers must be charged for a minimum of 3 hours prior
to use. This first charge will also turn ON the Pagers for use.
 The charging system is two stage, with a fast initial and then final
maintenance charge.
 Charging Pagers:
1. Insert Pagers into the
empty locations of a
powered (ON) Charger.
2. Each Pager’s LED will light.
3. The LED color indicates charging condition.
 Flashing yellow light = Battery charge very low. Charge needed.
Do not use the Pager.
 Solid yellow light = Charge needed.
 Solid green light = OK to use.
4. Pagers in use and returned to the Charger within 24 hours will fully
charge within three hours.
5. If not returned within 24 hours, charging time of up to 8
hours may be required to fully
charge batteries.
6. When not in the Charger, each Pager continues to
indicate battery charge condition:
 Flashing yellow light = Charge needed.
 Flashing green light = OK to use.
Charging and Storing Pagers:
 To maintain maximum battery capacity, store Pagers in the powered (ON)
Charger.
 If Pagers are left uncharged for more than 4
days, it is recommended to disconnect the
batteries until their next use. See “Replacing the
Battery” on page 11 for instructions.
 If left uncharged for extended periods of time, Pager
batteries can damage beyond repair and will need to be
replaced.
 When charged and stored properly, a battery life of 18-24
months can be expected before replacement is suggested.
Charging and Storing Pagers Connecting Power to Chargers