User's Manual
Table Of Contents
- QuikCall Pagers Cover Page 321045
- Introduction
- Pager C ertifications
- Pager Dimensions and Weights
- Charger Dimensions and Weights
- Charger Components
- Connecting Power
- Mounting Chargers
- Combining Chargers
- Charging and Storing Pagers
- Paging Using a Desktop Controller
- Paging Using a Kitchen Controller or Expeditor Panel
- Paging Using a Desktop Controller and Telephone
- Replacing the Clip
- Replacing the Insert
- Insert Dimensions
- Replacing the Battery
- System Warranty - Back Page
7
Paging Using a Desktop Controller:
1. Remove a Pager from the Charger.
2. The Pager will vibrate and it’s LEDs will flash to confirm it
is ready for use.
3. The Pager charge LED will continue to flash, confirming
the it is ready to receive a page.
4. Enter the number of the Pager on the Controller.
5. Press # or SEND button to send the page.
6. The XMIT light on the Controller will turn ON, confirming
the page is being sent.
7. The Pager will vibrate, tone or flash as required.
8. See “Enter Pager #” Menu instructions in your
Desktop Controller manual for more
information.
Paging Using a Desktop Controller