User's Manual

9
Paging Using a Desktop Controller and Telephone:
(Telco Module must be installed)
1. Remove the Pager you wish to page from
the Charger.
2. The Pager will flash and vibrate to confirm it is ready for
use.
3. The Pager charge LED will continue to flash, confirming it is
ready to receive a page.
4. Pick up the phone and listen for the dial tone.
5. Dial the phone number that has been assigned to the TELCO
Module installed.
6. Listen for a voice message from the telephone that confirms
the Controller is ready.
7. Within 8-10 seconds, using the telephone keypad, enter the
Pager number (up to 4 digits) and press the # button to send
the page.
8. A voice message heard on the phone confirms the message
was sent.
9. Hang up the telephone.
10. The Pager will receive a single, one second
vibration (factory setting).
11. See Paging instructions in your Desktop Controller
manual for more information.
Paging Using a IntelFlex Desktop Controller with Telco Module