Owners manual
2. Remove two pushpins from the top of the fascia. Do this on both sides of the vehicle. Set pushpins aside to
be reinstalled later.
3. Remove three metric bolts from the lower corner of fascia using the 10mm socket. To remove the bolt just
forward of the front tire, push fascia corner - where it meets bolt - out and then forward. Do this to both sides
of the vehicle. Set bolts aside to be reinstalled later.
2 3
Page 4 of 8 405-0109 Rev. C 3/23/11
5
4
4. Remove three pushpins from the lower front edge of fascia. Do this to both sides of the vehicle. Set pushpins
aside to be reinstalled later.
5. Push wheel well cover aside to remove one metric bolt using the 10mm socket. Do this to both sides of the
vehicle. Pull fascia forward to remove. Pull styrofoam bumper forward to remove from front of metal bumper.
Set fascia, styrofoam bumper and bolts aside carefully to be reinstalled later.
2010-12 Nissan Versa
Installation Instructions
BX1845
6
6. Remove one pushpin from metal bumper securing
the air dam (white arrow). Using the utility knife,
start cutting the air dam at the bottom of the tab
(grey arrow). Cut to the bottom of the air dam.
Remove cut portion of air dam. Pushpin will not be
reinstalled. Do this on both sides of the vehicle.