Owners manual

BX2724
2012 Kia Rio - Hatchback Only
Installation Instructions
405-0276 Page 6 of 9 4/18/12
7. To remove the front bumper, unclip the wiring harness and place it out of the way. Next, remove
the bumper using a 12MM socket for the two (2) outer bolts and 10MM socket for the center bolt
on the top of the bumper frame bracket. On the bottom of the bracket there are two (2) 12MM
bolts that need to be removed. Do this on both sides of the vehicle.
8. On the passenger side ONLY there is a plastic tab. Remove this tab by pulling upward. It will not
be reinstalled.
10. Remove the horn bracket located on the
passenger side. The horn will be relocated
after the baseplate has been installed.
9. Place the bumper upside down on a at,
steady surface.