Owners manual

BX3784
2008-12 Toyota Scion XB
(with fog lights)
Installation Instructions
405-0054 Rev. F Page 3 of 9 1/25/12
Vehicle Weight:
Motorhome mount tow bars are recommended for
use with this baseplate. Due to the design of the
removable tabs, the RangeFinderII, Adventurer,
and Ambassador tow bars can not be used. The
Acclaim tow bar may be used, but will not fold and
store on the front of the vehicle. Adapters, except
the BX8833 and BX88151, can not be used with
this baseplate.
Installation Notes: The radiator cover,
fascia, washer reservoir and vent tube are
removed and reinstalled during installation of
the baseplate. Drilling is required. Trimming
of the lower frame support webbing is
required.
The dimensional variations between otherwise
identical vehicles can be considerable.
While the baseplate was designed for easy
installation, it may be necessary to tailor the
baseplate slightly to compensate for auto
manufacturer’s tolerances. These minor
adjustments may include ling a hole slightly,
bending electrical rods or bending end plates.
The BX8869 Bulb and Socket Wiring Kit is
recommended for this vehicle.
1. Using a at screwdriver, remove four plastic
push pins from the radiator cover driver’s side
and with a 10MM socket, remove one bolt
from the outside edge (grey arrow). Set push
pins and bolt aside to be reinstalled later.
1





2. On the passenger side, using a at
screwdriver, remove ve plastic push pins and
with a 10MM socket, remove one metric bolt
on the outside edge (grey arrow). Set push
pins and bolt aside to be reinstalled later.

2






Possible location of the BX8869
Bulb & Socket Wiring Kit
Handling of some cosmetic parts
when installing this product may
require the use of protective covers,
rags, specialty tools, etc. to prevent
damage.