Owners manual

BX3784
2008-12 Toyota Scion XB
(with fog lights)
Installation Instructions
405-0054 Rev. F Page 5 of 9 1/25/12
8. Using a 10MM socket, remove the bolt from
between wheel well cover and left side of
washer reservoir on the passenger side only.
Disconnect all electrical and uid lines, then
remove reservoir and bolt. Set aside for later
reinstallation.
8

9
9. On the driver’s side, using a at screwdriver
remove the push pin holding the vent tube.
Also pull out the clip (grey arrow) from wire
loom. Move the vent tube out of the way.
Save the pin to reinstall later.



10A

10. On the driver’s side, remove the sensor and clip. Using a reciprocating saw, cut off the bracket
ush with lower radiator support. Be sure not to damage radiator.

10B