Owners manual

BX3784
2008-12 Toyota Scion XB
(with fog lights)
Installation Instructions
405-0054 Rev. F Page 6 of 9 1/25/12
14. On the passenger side, start a 6MM-1.0 x
30MM hex bolt in existing hole, the lower
front bolt location for the reservoir. Using the
baseplate as a template, drill three holes into
the frame and webbing with the 13/32” drill bit.
14

13. On the driver’s side, the back two bolts (white
arrows) are 3/8-16 x 1” hex bolts and 3/8” lock
washers with 3/8-16 hex nuts. The front two
(grey arrows) are 3/8-16 x 1 1/2” hex bolts
with 3/8” lock washers and 1/4” x 1” x 1” nut
plates inserted through the opening above the
baseplate. Tighten all bolts with Loctite Red.


13


11. Using a reciprocating saw, cut a notch 3 1/2” long by 3/4” in lower frame support webbing. Do this
on both sides. (Vertical cut should be ush with the side of support.)
11A


11B

Using a good quality paint, spray cut edges of frame to prevent rusting.
12. On the driver’s side, slide the baseplate
into the notch we cut out and as far back as
possible, it should be ush with back webbing.
Adjust to a level position with the vehicle and
clamp with large vise grips. Do this on both
sides. Using the baseplate as a template with
a 13/32” drill bit, drill all four holes.
12

When using power drills be aware of the
dangers of torque and drill bit length.