Owners manual

BX3833
2012 Volkswagen Passat SEL
Installation Instructions
405-0275 Page 6 of 7 4/25/12
10. Verify the baseplate is level and install the
3/8”-16 x 1-1/4” hex head bolts, 3/8” lock
washers and 3/8” ats washers on the
bottom slot. Do this on BOTH sides of the
vehicle.
11. Using a 13/32” drill bit and using the
baseplate as a template, drill the three (3)
sides holes. Do this on BOTH sides of the
vehicle.
12. Reattach the temperature sensor and front bumper padding.
13. Hold the front fascia as close to the original
state as possible and mark where the cutout
for the convenience links, attachment tabs
and breakaway switch, is so equipped, will
be located.
Set the front fascia down and notch the grill
to allow for proper clearance.
14. You may place the breakaway bracket
anywhere on the vehicle frame. Using a
9/32” drill bit, drill a hole into the frame.
15. Reinstall front fascia.