Instruction Manual

292-2215 7/02 8 of 10
initial setting, adjust to your driving preference if
needed. The location of the adjusting nut is shown
in Figure 23. The initial preload ranges are listed
in Figure 24.
10. Once you have the cable wrapped properly, pull
slowly on the other end of the cable while hold-
ing the pulleys and swage in place with the other
hand to prevent the cable from unwrapping. Keep
tension on the cable and slide the pulleys into the
AutoStop tube. (Figure 20) When the second set
of pulleys start into the tube, stop and remove the
Figure 21
ASSEMBLY INSTRUCTIONS
Figure 20
5/8 rod.
11. Pull slowly on the cable until the holes in the sec-
ond set of pulleys line up with the holes in the end
of the AutoStop tube and insert the 5/8 rod.
12. With the AutoStop still on its side, be sure that
the pulleys, cable anchor, and pulley divider are
all together and pressed down to the side of the
tube. Place a 20 thousanths inch (.020") feeler
gauge between the cable anchor and wide pulley
and tighten the set screw in the end of the cable
anchor. (Figure 21) NOTE: Be sure to keep the
5/8 rod centered in the AutoStop tube while tight-
ening the set screw.