Instruction Manual

Automatic Equipment Mfg. Co.

One Mill Road, Industrial Park l Pender, Nebraska 68047

292-5591 2/03 1 of 1

BX88133 Installation Instructions

BlueOx Baseplate Adapter

1. Slide receiver connector (2) into the attachment tabs extending out from the vehicle.

2. Line up the large 1/2 inch holes and insert pins.

3. Place the retaining plate (6) on the top and bottom of the 1/2 threaded rod on the receiver connector.

4. Secure the plates with 1/2 hex nut and lock washer.

5. Center the cross angle (1) on the top plate of the receiver connectors and secure with 1/2 inch bolts, lock

washers, and hex nuts.

6. Install the tow bar and safety cables according to the instructions included in their packages.

7. DEALER OR INSTALLER: BE CERTAIN THE USER RECEIVES THE INSTRUCTION SHEET.

Parts List

Ref. No. Qty. Part No. Description

1 1 61-5361 ..................................................................................................... Cross Angle

2 2 61-5360 .........................................................................................Receiver Connector

3 4 201-0011 ..................................................................................1/2-13 X 1 1/4 Hex Bolt

4 8 203-0012 ............................................................................................1/2 Lock Washer

5 8 202-0005 ............................................................................................... 1/2-13 Hex Nut

6 4 102-5781 ...............................................................................................Retaining Plate

7 4 203-0005 ............................................................................................. 1/2 Flat Washer

E XXXXXX ........................................................................................... Blue Ox Baseplate

PAGE 1
BX88133 Installation Instructions BlueOx Baseplate Adapter 1. Slide receiver connector (2) into the attachment tabs extending out from the vehicle. 2. Line up the large 1/2 inch holes and insert pins. 3. Place the retaining plate (6) on the top and bottom of the 1/2 threaded rod on the receiver connector. 4. Secure the plates with 1/2 hex nut and lock washer. 5. Center the cross angle (1) on the top plate of the receiver connectors and secure with 1/2 inch bolts, lock washers, and hex nuts. 6.