Manual

32
Tankcalibrationismostaccurateifperformedwhenthetankisascloseto
emptyaspossible.
Auto Calibration Procedure Selection Charts
If the tank is near empty: ≤10% Full
(thecurrenttanklevelwillbeassumedtobetheemptypointbythemeter)
Theamountofliquidaddedduring
calibrationcanbemeasured
YES NO
Theemptytank
capacityisknown
YES Procedure1(page33) Procedure1(page33)
NO Procedure1(page33) Procedure1
*
(page33)
If the tank is not empty: >10%–30% Full
Theamountofliquidaddedduring
calibrationcanbemeasured
YES NO
Theemptytank
capacityisknown
YES Procedure2(page37) Procedure3
†
(page41)
NO Procedure3
* †
(page41) Procedure3
* †
(page41)
*
Monitorwillonlybeabletocorrectlydisplaypercentage.Use100asthe
 fulltankcapacity.
†
Mustbeabletoestimatethepercentageofthetankthatislledatthestart
 ofAutoCalibration.
Tank Conguration (Auto Calibration)
Specicationssubjecttochange.Seewww.bluesea.comforcurrentinformation.
Afterfollowingsteps1–13onpages25–27,continuewiththeappropriate
AutoCalibrationprocedure.
WhenrunningtheAutoCalibrationitisimportantthatthecurrenttank’s
alarmsareturnedoffandthattheboatwillnottriggeranyalarmforother
systems.Ifanalarmoccurs,autocalibrationmustberunagainforaccurate
tankmetering.Itisrecommendedthattanklevelsareaslowassafely
possiblebeforerunningcalibration.Forgrayandblackwatertanks,fresh
watermaybeusedtollthetankduringcalibration.
TherearethreedifferentAutoCalibrationproceduresthatcanberun
dependingonwhatinformationisknown.UsetheAutoCalibration
ProcedureSelectionChartsonpage32todeterminetheneeded
informationandtheappropriateprocedurenumber.
31
Tank Conguration (Auto Calibration)
Specicationssubjecttochange.Seewww.bluesea.comforcurrentinformation.