Cov lus qhia

Bilge Setup

Changing System Labels

The M2 allows the user to change the labels that are displayed above each channel. Each channel can have a maximum of 16 characters however

in the summary screens only the rst 11 or 12 characters of the channel label are displayed.

Changing Label Names

To change the name of a bilge channel, follow the instructions below:

1. Navigate to the setup menu for the desired bilge channel. Menu->Setup->Bilge 1 Setup

2. In the battery setup menu, move the cursor to bilge channel name to be changed (indicated by the >> symbol)

3. Press Select to enter the name editing mode.

4. Use the LEFT ← and RIGHT → arrow buttons to move the cursor over the characters.

5. When the cursor is over a character, press Enter to edit that character. The cursor will start blinking.

6. Use the UP ↑ and DOWN ↓ arrow buttons to select a new character and press Ok to set that character.

7. Once all desired characters have been changed, press the Cancel button to exit the name editing mode.

Note: Although the maximum label length is 14 characters, some screens may only be able to display the rst 5 or so characters.

Additional Bilge Settings

The monitor provides custom settings for each bilge input. To access these settings, rst go to the Setup menu.

Scroll to the desired bilge channel.

The bilge setup settings are described below. To make a change, scroll to setting and press Enter. Press the LEFT ← or RIGHT → arrow buttons

to view the available setting options. Press Enter to save the setting. Press Cancel to cancel a change.

Enable

To display the bilge measurements, change this setting to ON. If enable is OFF, the bilge along with its measured values will not be displayed.

However, any associated alarm or relay settings are still activate. To de-active the alarm or relay, disable them in the Alarm Setup

and Relay Setup menus.

Cycle Reset

Resets the bilge cycle counter to zero.