Specifications

15
Operation
Idle Mode:
1. After the appliance has exited the Melt Cycle Mode, or on Start-Up if the Melt Cycle Mode was
by-passed, the appliance will go to the Idle Mode.
2. If the temperature is more than 10° below its Set Temperature, the display will show ’HEAt’
and the heating element is ‘ON’.
3. When the temperature is less than 10° below its Set Temperature the display will show ‘droP’.
4. The appliance also displays ‘droP’ when the temperature is equal to or higher than the Set
Temperature.
5. When the appliance displays ‘droP’ this indicates that the Fryer is ready to commence cooking
operations.
6. If there is a “.” displayed between the first and second characters of ‘HEAt’ this indicates that
the heating element is ‘ON’. The appliance uses a slope dependent (temperature vs time)
heating algorithm.
7. When idling around its Set Temperature, the appliance will usually maintain a temperature
range of 5° from the Set Temperature.
Cook Mode:
NOTE:
• Each Control Panel has 3 timers for each tank, which can be programmed with separate
cook times to allow different products with different cook times to be cooked in the same
tank.
• IMPORTANT; Only one temperature can be set for all 3 timers.
• Entering the Cook Mode does not exit the melt Cycle Mode.
1. The Cook Mode can be entered at any temperature, even when in the Melt Cycle Mode, by
pressing either the ‘1'-(Left), ‘2'-(Centre) or '3'-(Right) Timer keys, this will start the pre
programmed time set for each timer.
2. When only one timer is activated, the LED under the timer will blink rapidly and the time
remaining will be displayed.
3. When more than 1 timers are activated, the LED under the timer with the least remaining
time blinks more rapidly.
4. The LED's above the other active timers will blink less frequently.
5. When the first timer has expired and has not been cancelled the second timer’s LED turns
‘OFF’ until cancellation of the first timer.
6. If the second timer has not expired while the operator was cancelling the first timer, then it’s
time remaining is displayed and it’s LED will blink at the more rapidly.
7. When a timer expires, a beeping sound is generated and a blinking ‘L’ 'ctr' or ‘r’ is displayed
for either the left, centre or right timers respectively. This will continue until the expired
timer’s key is pressed to cancel the cooking for that timer.
8. An active timer may be cancelled at any time by pressing its ‘Timer’ key.
9. To turn the appliance ‘OFF’ depress and hold in the ‘ON' / 'OFF’ key for approximately 3
seconds. 'Off' will show in the display window.
Temperature Display Mode:
1. The appliance actual temperature and set temperatures can be displayed by depressing the
Temperature Key.
2. If the Temperature Key is depressed the actual temperature will be displayed.
3. If the Temperature Key is depressed again within approximately 3 seconds, the Set
Temperature is displayed.
4. Further depressing of the Temperature Key will enter the Idle Mode.
NOTE: The temperatures can be checked at any time except when in the Program Mode.